Introduction of Several Flame Spray Gun for Ceramic Rods

1.Master Jet flame spray gun

The spray gun weighs 2.5kg and can spray a wide range of spray materials. Different sizes of nozzles are used for different materials, like metal wire, core wire, cord material and ceramic rod. Motor drive can precisely feed wire, and it’s easy to install and set parameters. The guns can be mounted on the travel mechanism, and it is suitable for on-site or indoor operations for the light gun body. It is easy to handle and paint complex-shaped work pieces. The gun is economical with low-input, low gas consumption and high spray efficiency. Spraying the ceramic rod with a cord spray gun produces highly wear resistant coatings that are more wear resistant than plasma spray coatings.

2.Rokide flame spray gun

The uniqueness of the ROKIDE flame spray system is using ceramic rods. The bar is first melted and then the molten particles are deposited on the surface of the substrate at high speed. ROKIDE particles can’t leave the bar unless completely melted. These particles have high kinetic energy and thermal energy that can remain molten until they reach the surface of the substrate. Therefore, the ROKIDE coating has a high adhesion strength between particles. The ROKIDE system requires less capital investment (purchase, assembly, operation and maintenance). No cooling water or inert gas is required in the process. Daily maintenance is simple and usually does not require external technical support. The ROKIDE system is lighter and can effectively produce ceramic coatings with high wear resistance, high heat resistance and better electrical insulation.

3.Top Jet flame spray gun

The gun is a low cost investment allowing to produce ceramic coatings. It weighs 2.8kg and prays metal wires, core wires or flexi-cords. Top Jet has very rugged construction and design, it does not require specific assistance for maintenance. Gun is lightweight, making it easier to spray on complicated shapes by hand. Besides, it is easy to set-up for on-site job or in-house job. It has wide range of spray parameters applied for high spray rates or high quality surface treatment. Coatings are wear resistant with few internal stresses and able to operate at high temperature.

4.Z-Jet metallisation gun

It is a single application gun dedicated to corrosion protection coatings with Zinc or Zinc-Aluminum wires.Z-Jet has lightweight (2.2kg) and makes it the ideal metallisation gun used for long operation time on complicated shapes. It is very easy to set-up and use for on-site job or in-house job. The gun has very rugged construction and design and does not require specific assistance for maintenance. Wide range of spray parameters makes it easy to obtain high spray rates and high quality surface finishing.

Wisdom mainly produces Al2O3 ceramic rods, ZrO2 ceramic rods and Cr2O3 ceramic rods. It is known for its short delivery time and excellent quality, which has obvious advantages over other suppliers. Please feel free to contact us if needed.